Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 37-640 questions.
#6

Thanks for the info and I know what you are going to say, Dont turn on the radio until the capacitors are replaced. I have not learned to do this yet so i have not. I do have a 6' wire antenna connected but which screw? first is red, second is black, third is ground and 4 is unmarked.sorry to ask when you answered but i am no good with stage right or left....

As for the next questions: I need chassis training, I have been looking all over the getting started pages and found a few books for beginners but not sure which one is best for a complete novice.
   
   
   
Any suggestions or does anyone have one to sell me? Ill post it in wanted ads but i want to see what one to request.
1. Antique Radio Restoration Guide
2. Elements of Radio Servicing
3. The Radio Amateur's Handbook
4. Old Time Radios! Restoration and Repair
5. How to Repair Old-Time Radios

thanks all,
Kirk L


Messages In This Thread
Philco 37-640 questions. - by OldRestorer - 12-11-2013, 06:49 PM
RE: Philco 37-640 questions. - by Ron Ramirez - 12-11-2013, 06:56 PM
RE: Philco 37-640 questions. - by OldRestorer - 12-11-2013, 09:32 PM
RE: Philco 37-640 questions. - by Ron Ramirez - 12-11-2013, 09:36 PM
RE: Philco 37-640 questions. - by Warren - 12-11-2013, 10:15 PM
RE: Philco 37-640 questions. - by OldRestorer - 12-12-2013, 07:57 AM
RE: Philco 37-640 questions. - by OldRestorer - 12-12-2013, 08:13 AM
RE: Philco 37-640 questions. - by klondike98 - 12-12-2013, 11:14 AM
RE: Philco 37-640 questions. - by OldRestorer - 12-12-2013, 11:39 AM
RE: Philco 37-640 questions. - by klondike98 - 12-12-2013, 11:58 AM
RE: Philco 37-640 questions. - by Arran - 12-12-2013, 10:25 PM
RE: Philco 37-640 questions. - by klondike98 - 12-12-2013, 11:19 PM
RE: Philco 37-640 questions. - by OldRestorer - 12-13-2013, 07:44 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6090 online users. [Complete List]
» 1 Member(s) | 6089 Guest(s)
Avatar

>