Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 40-190 resistor
#22

Hello guy's and gals,
Well, I received a diagram from deckape of the wiring on that 84 tube in question.
He has one that he has restored and is quite familiar with this model.
I removed the diodes as well as the dogbone resistor and wired the electrolitic per the diagram.
The second electrolitic had a second 30uf/250 volt electrolitic wired in parallel with the second electrolitic, which should not be there.
Removed that as well.
Powers up fine, but still no audio.
Output transformer?
I will keep wittling away on this thing with the help of the forum people and maybe we can save it.
Thanks for the help,
murf


Messages In This Thread
Philco 40-190 resistor - by murf - 12-07-2013, 03:49 PM
RE: Philco 40-190 resistor - by Warren - 12-07-2013, 11:34 PM
RE: Philco 40-190 resistor - by murf - 12-08-2013, 12:28 AM
RE: Philco 40-190 resistor - by DeckApe - 12-08-2013, 10:08 AM
RE: Philco 40-190 resistor - by DeckApe - 12-08-2013, 11:47 AM
RE: Philco 40-190 resistor - by Mondial - 12-08-2013, 12:01 PM
RE: Philco 40-190 resistor - by murf - 12-08-2013, 01:03 PM
RE: Philco 40-190 resistor - by DeckApe - 12-08-2013, 04:13 PM
RE: Philco 40-190 resistor - by murf - 12-08-2013, 04:32 PM
RE: Philco 40-190 resistor - by DeckApe - 12-08-2013, 04:52 PM
RE: Philco 40-190 resistor - by murf - 12-08-2013, 05:12 PM
RE: Philco 40-190 resistor - by 37silverstreak - 12-08-2013, 06:52 PM
RE: Philco 40-190 resistor - by murf - 12-08-2013, 09:19 PM
RE: Philco 40-190 resistor - by Mondial - 12-08-2013, 09:33 PM
RE: Philco 40-190 resistor - by BrendaAnnD - 12-08-2013, 11:02 PM
RE: Philco 40-190 resistor - by BrendaAnnD - 12-08-2013, 11:03 PM
RE: Philco 40-190 resistor - by murf - 12-09-2013, 06:38 PM
RE: Philco 40-190 resistor - by 37silverstreak - 12-09-2013, 08:24 PM
RE: Philco 40-190 resistor - by DeckApe - 12-09-2013, 09:13 PM
RE: Philco 40-190 resistor - by murf - 12-09-2013, 09:38 PM
RE: Philco 40-190 resistor - by 37silverstreak - 12-09-2013, 11:26 PM
RE: Philco 40-190 resistor - by murf - 12-17-2013, 11:35 PM
RE: Philco 40-190 resistor - by Mondial - 12-18-2013, 12:03 AM
RE: Philco 40-190 resistor - by murf - 12-18-2013, 07:55 AM
RE: Philco 40-190 resistor - by murf - 12-21-2013, 05:48 PM
RE: Philco 40-190 resistor - by morzh - 12-21-2013, 07:58 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM

[-]
Who's Online
There are currently 3961 online users. [Complete List]
» 3 Member(s) | 3958 Guest(s)
AvatarAvatarAvatar

>