Philco model 18 (code 121) - HELP!
Posts: 16,570
Threads: 574
Joined: Oct 2011
City: Jackson
State, Province, Country: NJ
Either one will work fine I think.
The resistance is, I suspect, may not be of a high importance as, although I cannot find the spec on the field coil, I suspect its resistance is at least 10 times higher than that of the choke, and so the choke DC resistance will not affect voltages that much.
The inductance is good, and the ampacity is good too.
I'd go with the first one.
Messages In This Thread
RE: Philco model 18 (code 121) - HELP! - by morzh - 12-19-2013, 12:47 PM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
Philco 42-345 Restoration/Repair
|
Thank you Rod and Paul
I took a break, did some yard work and Rod "Therefore, it appears cap 40 is connected backw...osanders0311 — 06:35 PM |
Philco 45L Initial Check Up
|
Hello,
I am in the process of checking out a Philco 45L. My question is does this model suffer from the Philco coil r...dconant — 06:11 PM |
Table radio 51C or 52C?
|
Purchased a table radio at auction, not because I had to have it, but because no one else bid on it. $5 Unable to fi...antiqueradionut — 05:14 PM |
Philco 42-345 Restoration/Repair
|
The 2 towns you mentioned "Frustrated" and "Give Up" are places we have all been. Relax, take 5, thi...Paul Philco322 — 03:23 PM |
Philco 89 Code 123 Osc Coil
|
Thanks for posting that information!klondike98 — 03:14 PM |
Philco 42-345 Restoration/Repair
|
From what I see is the blue cap was added by someone after the radio was sold presumably to replace cap 40A. I can't tel...RodB — 03:12 PM |
Philco 42-345 Restoration/Repair
|
Correction
My original picture shows #40 cap, blue cap and #42 resistor connected.osanders0311 — 02:23 PM |
Philco 42-345 Restoration/Repair
|
Well guys I am stuck, frustrated and about ready to give up. For starters all I'm getting from the speaker is a humming ...osanders0311 — 02:17 PM |
[split] New member...
|
Thanks. I'll try that.HowardWoodard — 01:13 PM |
[split] New member...
|
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM |
Who's Online
|
There are currently 954 online users. [Complete List] » 2 Member(s) | 952 Guest(s)
|
|
|

|