Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My Christmas Present - 118MX
#1

This is my Christmas present. It's a Philco 118MX, I think... It's in splendid condition. The cabinet is excellent and the chassis looks super clean. It still has the original long wire antenna attached to the back. The cabinet also has a back cover that is labeled "Philco Echo Absorbing Screen"

I have a couple of questions though, and I'll post them under the photos.

   
   
   
   

There are two switches on the upper back of the cabinet. One is made by Philco and appears to be an antenna switch to swap the antenna to different bands on the radio. I've never seen one of these. The other is a flip switch on the upper right back. It has two capacitors inside it. I have no idea what it controls. There is no input jack. Any ideas?

Also, there are two stickers on the cabinet.. one says model 118, the other 118MX, so I am assuming this is a 118MX, correct?

The artist formerly known as Puhpow! 8)


Messages In This Thread
My Christmas Present - 118MX - by Jamie - 12-21-2013, 08:46 PM
RE: My Christmas Present - 118MX - by sam - 12-21-2013, 08:51 PM
RE: My Christmas Present - 118MX - by Jamie - 12-21-2013, 08:55 PM
RE: My Christmas Present - 118MX - by sam - 12-21-2013, 09:09 PM
RE: My Christmas Present - 118MX - by Jayce - 12-21-2013, 09:18 PM
RE: My Christmas Present - 118MX - by Arran - 12-21-2013, 09:41 PM
RE: My Christmas Present - 118MX - by Ron Ramirez - 12-21-2013, 10:17 PM
RE: My Christmas Present - 118MX - by Jamie - 12-22-2013, 03:12 PM
RE: My Christmas Present - 118MX - by sam - 12-22-2013, 04:23 PM
RE: My Christmas Present - 118MX - by Ron Ramirez - 12-22-2013, 07:54 PM
RE: My Christmas Present - 118MX - by Groundhog74 - 12-22-2013, 09:20 PM
RE: My Christmas Present - 118MX - by TA Forbes - 12-22-2013, 09:57 PM
RE: My Christmas Present - 118MX - by Jamie - 12-23-2013, 11:51 AM
RE: My Christmas Present - 118MX - by Mondial - 12-23-2013, 06:44 PM
RE: My Christmas Present - 118MX - by Jamie - 12-23-2013, 07:51 PM
RE: My Christmas Present - 118MX - by Joeztech - 12-23-2013, 07:53 PM
RE: My Christmas Present - 118MX - by KCMike - 12-23-2013, 08:12 PM
RE: My Christmas Present - 118MX - by Jamie - 12-23-2013, 11:12 PM
RE: My Christmas Present - 118MX - by Arran - 12-24-2013, 02:04 AM
RE: My Christmas Present - 118MX - by EricS - 12-26-2013, 09:10 PM
RE: My Christmas Present - 118MX - by Jamie - 01-08-2014, 04:47 PM
RE: My Christmas Present - 118MX - by gregb - 01-08-2014, 06:34 PM
RE: My Christmas Present - 118MX - by Jamie - 01-08-2014, 07:09 PM
RE: My Christmas Present - 118MX - by gregb - 01-08-2014, 09:14 PM
RE: My Christmas Present - 118MX - by gregb - 01-08-2014, 10:57 PM
RE: My Christmas Present - 118MX - by Jamie - 01-09-2014, 03:33 PM
RE: My Christmas Present - 118MX - by gregb - 01-09-2014, 03:40 PM
RE: My Christmas Present - 118MX - by Jamie - 01-09-2014, 06:00 PM
RE: My Christmas Present - 118MX - by vinzer - 01-09-2014, 08:08 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 4437 online users. [Complete List]
» 2 Member(s) | 4435 Guest(s)
AvatarAvatar

>