1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
My Christmas Present - 118MX
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#8

12-21-2013, 10:17 PM
Hey Jamie, NICE find! Icon_thumbup

If the switch connected to the antenna has the Philco name on it, then it was originally part of Philco's Three Purpose Antenna System and was intended to be switched from the "standard wave" (AM) position to the "short wave" position when you switched your radio from AM to SW. I have one of those switches around here someplace.

As for the other switch, I have no idea...obviously not original...
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »


Messages In This Thread
My Christmas Present - 118MX - by Jamie - 12-21-2013, 08:46 PM
RE: My Christmas Present - 118MX - by sam - 12-21-2013, 08:51 PM
RE: My Christmas Present - 118MX - by Jamie - 12-21-2013, 08:55 PM
RE: My Christmas Present - 118MX - by sam - 12-21-2013, 09:09 PM
RE: My Christmas Present - 118MX - by Jayce - 12-21-2013, 09:18 PM
RE: My Christmas Present - 118MX - by Arran - 12-21-2013, 09:41 PM
RE: My Christmas Present - 118MX - by Ron Ramirez - 12-21-2013, 10:17 PM
RE: My Christmas Present - 118MX - by Jamie - 12-22-2013, 03:12 PM
RE: My Christmas Present - 118MX - by sam - 12-22-2013, 04:23 PM
RE: My Christmas Present - 118MX - by Ron Ramirez - 12-22-2013, 07:54 PM
RE: My Christmas Present - 118MX - by Groundhog74 - 12-22-2013, 09:20 PM
RE: My Christmas Present - 118MX - by TA Forbes - 12-22-2013, 09:57 PM
RE: My Christmas Present - 118MX - by Jamie - 12-23-2013, 11:51 AM
RE: My Christmas Present - 118MX - by Mondial - 12-23-2013, 06:44 PM
RE: My Christmas Present - 118MX - by Jamie - 12-23-2013, 07:51 PM
RE: My Christmas Present - 118MX - by Joeztech - 12-23-2013, 07:53 PM
RE: My Christmas Present - 118MX - by KCMike - 12-23-2013, 08:12 PM
RE: My Christmas Present - 118MX - by Jamie - 12-23-2013, 11:12 PM
RE: My Christmas Present - 118MX - by Arran - 12-24-2013, 02:04 AM
RE: My Christmas Present - 118MX - by EricS - 12-26-2013, 09:10 PM
RE: My Christmas Present - 118MX - by Jamie - 01-08-2014, 04:47 PM
RE: My Christmas Present - 118MX - by gregb - 01-08-2014, 06:34 PM
RE: My Christmas Present - 118MX - by Jamie - 01-08-2014, 07:09 PM
RE: My Christmas Present - 118MX - by gregb - 01-08-2014, 09:14 PM
RE: My Christmas Present - 118MX - by gregb - 01-08-2014, 10:57 PM
RE: My Christmas Present - 118MX - by Jamie - 01-09-2014, 03:33 PM
RE: My Christmas Present - 118MX - by gregb - 01-09-2014, 03:40 PM
RE: My Christmas Present - 118MX - by Jamie - 01-09-2014, 06:00 PM
RE: My Christmas Present - 118MX - by vinzer - 01-09-2014, 08:08 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 4505 online users. [Complete List]
» 3 Member(s) | 4502 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios