Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

Philco 41-315X
#13

Just this morning was looking at the pilot lamp of the 42-400 I'm working on and found this thread. Awesome. Ordered a few of the 220V lamps from Amazon for this one and a 42-1015 next up on the rack.
I'm really getting to like these immediate pre-war consoles. The 42-400 with the 14" speaker makes for fairly good powerful sound..but like Ron says a bit strong on the bass...
This one had a phono jack so with a small passive amp/resistor it is playing my internet radio etc.
The rubber wire confounds me at times...the pilot lamp on this one...the red wire was nearly dust while the green was still pliable and not needing replacement. Some of the red below deck was also crumbling but again some was just fine. It seems also that if you don't poke the bear(rubber wiring) it is just fine.
Again thanks for the pilot lamp tip and congrats on a decent restoration! Looks awesome....


Messages In This Thread
Philco 41-315X - by bfrohwein - 11-08-2013, 01:35 AM
RE: Philco 41-315X - by Bill Kinghorn - 11-08-2013, 01:08 PM
RE: Philco 41-315X - by bfrohwein - 11-08-2013, 02:06 PM
RE: Philco 41-315X - by Ron Ramirez - 11-08-2013, 06:08 PM
RE: Philco 41-315X - by bfrohwein - 11-08-2013, 07:23 PM
RE: Philco 41-315X - by Bill Kinghorn - 11-09-2013, 03:41 PM
RE: Philco 41-315X - by bfrohwein - 11-09-2013, 07:00 PM
RE: Philco 41-315X - by Arran - 11-09-2013, 11:14 PM
RE: Philco 41-315X - by bfrohwein - 12-08-2013, 11:56 PM
RE: Philco 41-315X - by Ron Ramirez - 12-10-2013, 06:11 PM
RE: Philco 41-315X - by bfrohwein - 12-10-2013, 09:34 PM
RE: Philco 41-315X - by bfrohwein - 12-16-2013, 07:02 PM
RE: Philco 41-315X - by jeffgniffke - 12-22-2013, 03:53 PM
RE: Philco 41-315X - by bfrohwein - 12-22-2013, 06:56 PM
RE: Philco 41-315X - by jeffgniffke - 12-23-2013, 04:53 PM
RE: Philco 41-315X - by Ron Ramirez - 12-23-2013, 05:29 PM
RE: Philco 41-315X - by bfrohwein - 12-24-2013, 02:43 PM
RE: Philco 41-315X - by Joeztech - 12-25-2013, 10:46 AM
RE: Philco 41-315X - by bfrohwein - 12-25-2013, 12:46 PM
RE: Philco 41-315X - by Ron Ramirez - 12-25-2013, 12:48 PM
RE: Philco 41-315X - by jeffgniffke - 12-26-2013, 05:49 PM
RE: Philco 41-315X - by bfrohwein - 12-26-2013, 06:59 PM
RE: Philco 41-315X - by jeffgniffke - 12-26-2013, 07:06 PM
RE: Philco 41-315X - by bfrohwein - 01-01-2014, 03:59 PM
RE: Philco 41-315X - by jeffgniffke - 01-01-2014, 09:14 PM
RE: Philco 41-315X - by jeffgniffke - 01-01-2014, 09:19 PM
RE: Philco 41-315X - by jeffgniffke - 01-10-2014, 01:08 PM
RE: Philco 41-315X - by PhilcoMike - 01-10-2014, 03:39 PM
RE: Philco 41-315X - by Ron Ramirez - 01-10-2014, 05:57 PM
RE: Philco 41-315X - by jeffgniffke - 02-04-2014, 12:38 PM
RE: Philco 41-315X - by vinzer - 02-04-2014, 06:45 PM
RE: Philco 41-315X - by jeffgniffke - 06-09-2014, 06:18 PM
RE: Philco 41-315X - by bfrohwein - 06-09-2014, 07:08 PM
RE: Philco 41-315X - by bfrohwein - 06-09-2014, 07:14 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
54C Complete Teardown/Rebuild
Hello Roy, here is this one sincerely Richardradiorich — 12:45 AM
54C Complete Teardown/Rebuild
Richard, Had grabbed it already but thank you just the same.  I find myself wanting to find some way to block out the...glyphmon — 12:03 AM
54C Complete Teardown/Rebuild
Hello roy, here is a link to the schematic . Sincerely Richardradiorich — 11:54 PM
54C Complete Teardown/Rebuild
Richard, The Silvertone 2014 also is a transformerless set, so I am incorporating a 1:1 600 ohm audio isolation transfo...glyphmon — 11:37 PM
Preliminary work on wife's Silvertone 2014
Did an alignment today which was interesting.  IF alignment went great, almost all was already spot-on.  Adjusting on th...glyphmon — 11:35 PM
54C Complete Teardown/Rebuild
The main problem with adding a Bluetooth input is that this set lacks a traditional power transformer to isolate it from...radiorich — 11:19 PM
54C Cabinet Refinish
I started stripping this cabinet before it got super chilly out because I knew I wasn't going to be able to work on ...glyphmon — 11:18 PM
54C Complete Teardown/Rebuild
While I'm waiting to wrap up the final steps on my wife's Silvertone 2014, I started disassembly on the next project.  O...glyphmon — 11:07 PM
Preliminary work on wife's Silvertone 2014
Hello roy, that great news glad it worked out for you !! Sincerely Richardradiorich — 10:50 PM
Preliminary work on wife's Silvertone 2014
Safety caps arrived today.  Soldered one in and had a successful first power-up.  No magic smoke escaped and it tunes in...glyphmon — 09:53 PM

[-]
Who's Online
There are currently no members online.

>