This Was In My Xmas Card!

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

This Was In My Xmas Card!

jerryhawthorne
Phorum Expert

Posts: 1,562
Threads: 56
Joined: Nov 2008
City: Sedona, AZ/Placentia/CA

12-27-2013, 04:27 PM

Craig, mine were shot too. Seems there is a site that makes reproduction rubber parts and I found just what I needed. Perhaps someone can lead you there. For the unobtainable tube layout that goes on the top of the shield try this:
http://philcoradio.com/phorum/showthread.php?tid=6987

For the small label on the back of the the shield, try this:

http://philcoradio.com/phorum/showthread.php?tid=5165

I just hate to not have the labels on a radio and those on the tube shield don't seem to stay on for ever!
Have fun, it is a nice radio you have.

Jerry

A friend in need is a pest! Bill Slee ca 1970.

Find

« Next Oldest | Next Newest »

Messages In This Thread

This Was In My Xmas Card! - by VntgRads - 12-27-2013, 03:02 PM

RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 03:04 PM

RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 03:17 PM

RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 03:39 PM

RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 03:58 PM

RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 04:27 PM

RE: This Was In My Xmas Card! - by Jayce - 12-27-2013, 04:33 PM

RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 06:08 PM

RE: This Was In My Xmas Card! - by Ron Ramirez - 12-27-2013, 06:15 PM

RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 06:21 PM

RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 06:46 PM

RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 07:45 PM

RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 08:18 PM

RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 09:29 PM

RE: This Was In My Xmas Card! - by Jamie - 12-27-2013, 09:51 PM

RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 10:06 PM

RE: This Was In My Xmas Card! - by EricS - 12-27-2013, 10:20 PM

RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 10:45 PM

RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 11:12 PM

RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 11:28 PM

RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 11:32 PM

RE: This Was In My Xmas Card! - by TA Forbes - 12-28-2013, 10:56 AM

RE: This Was In My Xmas Card! - by Gene Pederson - 12-28-2013, 08:31 PM

RE: This Was In My Xmas Card! - by VntgRads - 12-28-2013, 11:17 PM

RE: This Was In My Xmas Card! - by TA Forbes - 12-29-2013, 11:16 AM

RE: This Was In My Xmas Card! - by LASJayhawk - 12-29-2013, 12:57 PM

View a Printable Version

Users browsing this thread: 5 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6738 online users. [Complete List]
» 1 Member(s) | 6737 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me