1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
This Was In My Xmas Card!
VntgRads
Member
***
Posts: 246
Threads: 27
Joined: Aug 2013
City: Petaluma, CA
#8

12-27-2013, 06:08 PM
Jerry: Thanks for the links. I just need to get some proper colored paper for the back label and to verify the label dimensions. I think RadioDaze carries the rubber chassis doughnuts.

Jayce: You are right about these radios. I have been listening to this unit since I bought it yesterday and it works great! There is absolutely NO HUM! Not sure if it has ever been worked on or not. The gentleman at the antique store, who was somewhat knowledgeable regarding vintage radios, was sure it had been worked on before only because it sounded so good! I will see when I take the chassis out.

Craig R.
Find
« Next Oldest | Next Newest »


Messages In This Thread
This Was In My Xmas Card! - by VntgRads - 12-27-2013, 03:02 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 03:04 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 03:17 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 03:39 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 03:58 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 04:27 PM
RE: This Was In My Xmas Card! - by Jayce - 12-27-2013, 04:33 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 06:08 PM
RE: This Was In My Xmas Card! - by Ron Ramirez - 12-27-2013, 06:15 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 06:21 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 06:46 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 07:45 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 08:18 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 09:29 PM
RE: This Was In My Xmas Card! - by Jamie - 12-27-2013, 09:51 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 10:06 PM
RE: This Was In My Xmas Card! - by EricS - 12-27-2013, 10:20 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 10:45 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 11:12 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 11:28 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 11:32 PM
RE: This Was In My Xmas Card! - by TA Forbes - 12-28-2013, 10:56 AM
RE: This Was In My Xmas Card! - by Gene Pederson - 12-28-2013, 08:31 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-28-2013, 11:17 PM
RE: This Was In My Xmas Card! - by TA Forbes - 12-29-2013, 11:16 AM
RE: This Was In My Xmas Card! - by LASJayhawk - 12-29-2013, 12:57 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6814 online users. [Complete List]
» 1 Member(s) | 6813 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios