Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

This Was In My Xmas Card!
#17

What a gorgeous radio! And what a great gift! The best cleaner is some Goop or GoJo (no pumice). Apply with a cloth, rub gently (always with the grain) and wipe clean. It might take more than one application to get it clean, depending on just how dirty it is. It will have a wet and shiny look for a few hours while it dries. Chances are a little Howard Restore-a-finish after that will bring it back to a near new appearance if the original finish is still largely intact. This is about as clean as I know how to make it.


Messages In This Thread
This Was In My Xmas Card! - by VntgRads - 12-27-2013, 03:02 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 03:04 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 03:17 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 03:39 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 03:58 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 04:27 PM
RE: This Was In My Xmas Card! - by Jayce - 12-27-2013, 04:33 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 06:08 PM
RE: This Was In My Xmas Card! - by Ron Ramirez - 12-27-2013, 06:15 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 06:21 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 06:46 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 07:45 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 08:18 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 09:29 PM
RE: This Was In My Xmas Card! - by Jamie - 12-27-2013, 09:51 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 10:06 PM
RE: This Was In My Xmas Card! - by EricS - 12-27-2013, 10:20 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 10:45 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 11:12 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-27-2013, 11:28 PM
RE: This Was In My Xmas Card! - by jerryhawthorne - 12-27-2013, 11:32 PM
RE: This Was In My Xmas Card! - by TA Forbes - 12-28-2013, 10:56 AM
RE: This Was In My Xmas Card! - by Gene Pederson - 12-28-2013, 08:31 PM
RE: This Was In My Xmas Card! - by VntgRads - 12-28-2013, 11:17 PM
RE: This Was In My Xmas Card! - by TA Forbes - 12-29-2013, 11:16 AM
RE: This Was In My Xmas Card! - by LASJayhawk - 12-29-2013, 12:57 PM



Users browsing this thread: 6 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6846 online users. [Complete List]
» 1 Member(s) | 6845 Guest(s)
Avatar

>