1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
370 Chairside Back to Life
RoyG
Member
***
Posts: 53
Threads: 20
Joined: May 2013
City: Portland, OR
#1

12-30-2013, 02:17 PM
Finished my first radio. Its a 370 Chairside that I picked up for $35 earlier in the year. Went through the chassis replaced all the paper caps and electrolytics along with one mica and all but one resistor. Couldn't figure out why I couldn't get any stations until I discovered that a previous repair at some point in it's life rendered it inoperable. Cathode of the oscillator was not wired back to the B.C. Resistor.

   
   
Find
« Next Oldest | Next Newest »


Messages In This Thread
370 Chairside Back to Life - by RoyG - 12-30-2013, 02:17 PM
RE: 370 Chairside Back to Life - by Radioroslyn - 12-30-2013, 08:33 PM
RE: 370 Chairside Back to Life - by VntgRads - 12-30-2013, 10:59 PM
RE: 370 Chairside Back to Life - by klondike98 - 12-30-2013, 11:16 PM
RE: 370 Chairside Back to Life - by wireless - 12-31-2013, 05:36 PM
RE: 370 Chairside Back to Life - by TA Forbes - 12-31-2013, 11:22 PM
RE: 370 Chairside Back to Life - by jontz - 01-01-2014, 11:18 AM
RE: 370 Chairside Back to Life - by RoyG - 01-02-2014, 03:49 PM
RE: 370 Chairside Back to Life - by Radioroslyn - 01-02-2014, 05:10 PM
RE: 370 Chairside Back to Life - by RoyG - 01-03-2014, 03:42 AM
RE: 370 Chairside Back to Life - by morzh - 01-03-2014, 09:15 PM
RE: 370 Chairside Back to Life - by PhilcoJohn - 01-06-2014, 07:40 PM
RE: 370 Chairside Back to Life - by Radioroslyn - 01-06-2014, 11:22 PM



Users browsing this thread: 7 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios