Philco 41-315X

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 41-315X

jeffgniffke
Junior Member

Posts: 46
Threads: 7
Joined: Apr 2013
City: Grand Marais, MN 55604

#25

01-01-2014, 09:14 PM

Picture of the 42-400...with the pilot lamp lit nicely. There must be a pin hole on the bottom of the lens or hole as i get a small red dot below the lamp... Running great...with the exception of the old FM dropped and wired for phono (button on the control head). Using the rebuilt phono jack for internet radio etc etc. Tommorow I'll give a shot at painting the escutcheon. I picked the paints up so ready to do it.....

Attached Files Image(s)

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 41-315X - by bfrohwein - 11-08-2013, 01:35 AM

RE: Philco 41-315X - by Bill Kinghorn - 11-08-2013, 01:08 PM

RE: Philco 41-315X - by bfrohwein - 11-08-2013, 02:06 PM

RE: Philco 41-315X - by Ron Ramirez - 11-08-2013, 06:08 PM

RE: Philco 41-315X - by bfrohwein - 11-08-2013, 07:23 PM

RE: Philco 41-315X - by Bill Kinghorn - 11-09-2013, 03:41 PM

RE: Philco 41-315X - by bfrohwein - 11-09-2013, 07:00 PM

RE: Philco 41-315X - by Arran - 11-09-2013, 11:14 PM

RE: Philco 41-315X - by bfrohwein - 12-08-2013, 11:56 PM

RE: Philco 41-315X - by Ron Ramirez - 12-10-2013, 06:11 PM

RE: Philco 41-315X - by bfrohwein - 12-10-2013, 09:34 PM

RE: Philco 41-315X - by bfrohwein - 12-16-2013, 07:02 PM

RE: Philco 41-315X - by jeffgniffke - 12-22-2013, 03:53 PM

RE: Philco 41-315X - by bfrohwein - 12-22-2013, 06:56 PM

RE: Philco 41-315X - by jeffgniffke - 12-23-2013, 04:53 PM

RE: Philco 41-315X - by Ron Ramirez - 12-23-2013, 05:29 PM

RE: Philco 41-315X - by bfrohwein - 12-24-2013, 02:43 PM

RE: Philco 41-315X - by Joeztech - 12-25-2013, 10:46 AM

RE: Philco 41-315X - by bfrohwein - 12-25-2013, 12:46 PM

RE: Philco 41-315X - by Ron Ramirez - 12-25-2013, 12:48 PM

RE: Philco 41-315X - by jeffgniffke - 12-26-2013, 05:49 PM

RE: Philco 41-315X - by bfrohwein - 12-26-2013, 06:59 PM

RE: Philco 41-315X - by jeffgniffke - 12-26-2013, 07:06 PM

RE: Philco 41-315X - by bfrohwein - 01-01-2014, 03:59 PM

RE: Philco 41-315X - by jeffgniffke - 01-01-2014, 09:14 PM

RE: Philco 41-315X - by jeffgniffke - 01-01-2014, 09:19 PM

RE: Philco 41-315X - by jeffgniffke - 01-10-2014, 01:08 PM

RE: Philco 41-315X - by PhilcoMike - 01-10-2014, 03:39 PM

RE: Philco 41-315X - by Ron Ramirez - 01-10-2014, 05:57 PM

RE: Philco 41-315X - by jeffgniffke - 02-04-2014, 12:38 PM

RE: Philco 41-315X - by vinzer - 02-04-2014, 06:45 PM

RE: Philco 41-315X - by jeffgniffke - 06-09-2014, 06:18 PM

RE: Philco 41-315X - by bfrohwein - 06-09-2014, 07:08 PM

RE: Philco 41-315X - by bfrohwein - 06-09-2014, 07:14 PM

View a Printable Version

Users browsing this thread: 6 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6852 online users. [Complete List]
» 1 Member(s) | 6851 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me