New to the Forum

Thread Rating:

New to the Forum

triggh04
Junior Member

Posts: 8
Threads: 2
Joined: Jan 2014
City: Ruther Glen, VA

01-02-2014, 06:16 PM

more pictures

Attached Files Image(s)

Find

« Next Oldest | Next Newest »

Messages In This Thread

New to the Forum - by triggh04 - 01-02-2014, 05:42 PM

RE: New to the Forum - by triggh04 - 01-02-2014, 06:16 PM

RE: New to the Forum - by hsusmann - 01-02-2014, 06:23 PM

RE: New to the Forum - by ipwizard - 01-02-2014, 07:35 PM

RE: New to the Forum - by triggh04 - 01-02-2014, 08:20 PM

RE: New to the Forum - by morzh - 01-02-2014, 08:39 PM

RE: New to the Forum - by triggh04 - 01-02-2014, 10:14 PM

RE: New to the Forum - by hsusmann - 01-02-2014, 10:41 PM

RE: New to the Forum - by triggh04 - 01-03-2014, 08:53 PM

RE: New to the Forum - by morzh - 01-03-2014, 09:07 PM

RE: New to the Forum - by triggh04 - 01-03-2014, 09:17 PM

RE: New to the Forum - by morzh - 01-03-2014, 09:56 PM

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 4662 online users. [Complete List]
» 2 Member(s) | 4660 Guest(s)