Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

New to the Forum
#6

Trigg

Sorry to rain on it but whatever makes this tick, is not at all a good beginner's project. To be thoroughly honest, this one is not a good project period. I would never pay anything for this nor would I take it for free, except maybe the chassis for parts provided there are any good parts in a chassis that's been through what this one has. It looks pretty darn bad. So does the cabinet. I do not have it in me to take on a radio like this one.
Of course if you really feel like doing this one, go for it, we will help you as much as possible.....

I hope you got it for next to nothing, or someone paid you to remove it. Icon_smile


Messages In This Thread
New to the Forum - by triggh04 - 01-02-2014, 05:42 PM
RE: New to the Forum - by triggh04 - 01-02-2014, 06:16 PM
RE: New to the Forum - by hsusmann - 01-02-2014, 06:23 PM
RE: New to the Forum - by ipwizard - 01-02-2014, 07:35 PM
RE: New to the Forum - by triggh04 - 01-02-2014, 08:20 PM
RE: New to the Forum - by morzh - 01-02-2014, 08:39 PM
RE: New to the Forum - by klondike98 - 01-02-2014, 09:50 PM
RE: New to the Forum - by triggh04 - 01-02-2014, 10:14 PM
RE: New to the Forum - by hsusmann - 01-02-2014, 10:41 PM
RE: New to the Forum - by klondike98 - 01-02-2014, 10:53 PM
RE: New to the Forum - by klondike98 - 01-02-2014, 11:40 PM
RE: New to the Forum - by TA Forbes - 01-02-2014, 11:59 PM
RE: New to the Forum - by LASJayhawk - 01-03-2014, 08:48 PM
RE: New to the Forum - by triggh04 - 01-03-2014, 08:53 PM
RE: New to the Forum - by morzh - 01-03-2014, 09:07 PM
RE: New to the Forum - by triggh04 - 01-03-2014, 09:17 PM
RE: New to the Forum - by morzh - 01-03-2014, 09:56 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 4638 online users. [Complete List]
» 3 Member(s) | 4635 Guest(s)
AvatarAvatarAvatar

>