Help ID parts Canadian Model 91H

Thread Rating:

TRusselo
New Member

Posts: 2
Threads: 1
Joined: Jan 2014
City: Canada

01-03-2014, 03:46 AM

thought it might be neat for you guys to see this too.

[Image: https://dl.dropboxusercontent.com/u/1920....32.40.jpg]

Its interesting that this sticker above, from inside the case is dated for september 1 1932, and the manufacture date on the speakers were september 30 1932.

[Image: https://dl.dropboxusercontent.com/u/1920....34.58.jpg]

[Image: https://dl.dropboxusercontent.com/u/1920....34.32.jpg]

[Image: https://dl.dropboxusercontent.com/u/1920....06.20.jpg]

(This post was last modified: 01-03-2014, 03:50 AM by TRusselo.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

RE: Help ID parts Canadian Model 91H - by TRusselo - 01-03-2014, 03:46 AM

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6756 online users. [Complete List]
» 1 Member(s) | 6755 Guest(s)