testing equipment

Thread Rating:

1 Vote(s) - 4 Average
1
2
3
4
5

Linear Mode

testing equipment

morzh
Odobenus rosmarus

Posts: 15,818
Threads: 554
Joined: Oct 2011
City: Jackson, NJ

#16

01-16-2014, 04:19 PM

OK I take it, it does not check diodes.

Well, you could go to Ohms.

But first, please go to that topic in "electronic restoration" you started and do check that capacitor - it is close to 99% chance this is your problem if it is the board (unless you have a bad crystal).

Find

« Next Oldest | Next Newest »

Messages In This Thread

testing equipment - by tim1 - 01-16-2014, 12:35 AM

RE: testing equipment - by TA Forbes - 01-16-2014, 10:40 AM

RE: testing equipment - by morzh - 01-16-2014, 10:47 AM

RE: testing equipment - by TA Forbes - 01-16-2014, 10:54 AM

RE: testing equipment - by TV MAN - 01-16-2014, 11:00 AM

RE: testing equipment - by morzh - 01-16-2014, 02:47 PM

RE: testing equipment - by jontz - 01-16-2014, 02:56 PM

RE: testing equipment - by morzh - 01-16-2014, 03:04 PM

RE: testing equipment - by tim1 - 01-16-2014, 03:07 PM

RE: testing equipment - by morzh - 01-16-2014, 03:12 PM

RE: testing equipment - by jontz - 01-16-2014, 03:27 PM

RE: testing equipment - by morzh - 01-16-2014, 03:30 PM

RE: testing equipment - by jontz - 01-16-2014, 03:33 PM

RE: testing equipment - by morzh - 01-16-2014, 03:33 PM

RE: testing equipment - by tim1 - 01-16-2014, 04:10 PM

RE: testing equipment - by morzh - 01-16-2014, 04:19 PM

RE: testing equipment - by tim1 - 01-16-2014, 05:32 PM

RE: testing equipment - by morzh - 01-16-2014, 05:35 PM

RE: testing equipment - by TV MAN - 01-16-2014, 09:55 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 3704 online users. [Complete List]
» 2 Member(s) | 3702 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me