Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Hello from new member
#11

Welcome to the Phorum, Tim!

Make yourself comfortable a sit a spell.

It's not how bad you mess up, it's how well you can recover.


Messages In This Thread
Hello from new member - by tim1 - 01-16-2014, 12:21 AM
RE: Hello from new member - by klondike98 - 01-16-2014, 08:59 AM
RE: Hello from new member - by Eric Adams - 01-16-2014, 10:31 AM
RE: Hello from new member - by TA Forbes - 01-16-2014, 10:38 AM
RE: Hello from new member - by hsusmann - 01-16-2014, 10:52 AM
RE: Hello from new member - by Tom Hamilton - 01-16-2014, 02:24 PM
RE: Hello from new member - by codefox1 - 01-16-2014, 05:41 PM
RE: Hello from new member - by gregb - 01-16-2014, 06:08 PM
RE: Hello from new member - by GarySP - 01-18-2014, 03:53 PM
RE: Hello from new member - by PAradiogeek - 01-18-2014, 10:00 PM
RE: Hello from new member - by Eric T - 01-18-2014, 10:28 PM
RE: Hello from new member - by Ron Ramirez - 01-19-2014, 10:40 AM
RE: Hello from new member - by KCMike - 01-19-2014, 04:55 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 4159 online users. [Complete List]
» 1 Member(s) | 4158 Guest(s)
Avatar

>