Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Puzzled Over 118MX
#4

It's been on the bench, playing perfectly, for several hours now. My fear is that, being upside down on the bench, there is a lot of air circulation and it wont get hot enough to reproduce the trouble. I poked and prodded with a wooden stick and found nothing. Mike sent me a PM that should help narrow down the search. I did leave several old dog bones in the radio, and my gut tells me that's where the problem lies. Chuck, I checked resistor #61 as soon as I first pulled the chassis, it checked out fine - but it had cooled off by then too.

I may have to put it back in the cabinet to get it hot enough. Or else, maybe cover it up with something on the bench? It's a heavy chassis and I'm no spring chicken... any ideas on that?

The artist formerly known as Puhpow! 8)


Messages In This Thread
Puzzled Over 118MX - by Jamie - 01-22-2014, 05:05 PM
RE: Puzzled Over 118MX - by Mondial - 01-22-2014, 05:19 PM
RE: Puzzled Over 118MX - by Chuck Schwark - 01-22-2014, 05:22 PM
RE: Puzzled Over 118MX - by Jamie - 01-22-2014, 06:22 PM
RE: Puzzled Over 118MX - by jontz - 01-22-2014, 06:30 PM
RE: Puzzled Over 118MX - by morzh - 01-22-2014, 06:53 PM
RE: Puzzled Over 118MX - by Radioroslyn - 01-22-2014, 08:46 PM
RE: Puzzled Over 118MX - by Chuck Schwark - 01-23-2014, 12:53 AM
RE: Puzzled Over 118MX - by Arran - 01-23-2014, 02:21 AM
RE: Puzzled Over 118MX - by BrendaAnnD - 01-23-2014, 03:04 AM
RE: Puzzled Over 118MX - by TV MAN - 01-23-2014, 11:15 AM
RE: Puzzled Over 118MX - by BrendaAnnD - 01-23-2014, 12:27 PM
RE: Puzzled Over 118MX - by Jamie - 01-23-2014, 02:00 PM
RE: Puzzled Over 118MX - by morzh - 01-23-2014, 02:40 PM
RE: Puzzled Over 118MX - by tab10672 - 01-23-2014, 03:37 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently 2485 online users. [Complete List]
» 1 Member(s) | 2484 Guest(s)
Avatar

>