Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

PHILCO 41-608 ADJUSTMENTS
#3

Thanks Randy. I have tried adjusting it and get no change in intensity. I am going to pull out the chassis and take a look for a broken wire, or clean it as you mentioned. I have the "table top record player" from 1941 that I just restored, and it has the adjustment on the back of the chassis (which is where it should be), and it adjusts just fine, and I get no microphonics. As for the 41-608, I think it is too bright and that is why I cannot turn it up too high. I need to syncronize the volume between the radio and record player better.

Thanks,


Messages In This Thread
PHILCO 41-608 ADJUSTMENTS - by davidff - 02-06-2012, 09:50 AM
RE: PHILCO 41-608 ADJUSTMENTS - by Randy H. - 01-23-2014, 07:33 PM
RE: PHILCO 41-608 ADJUSTMENTS - by davidff - 01-24-2014, 11:22 AM
RE: PHILCO 41-608 ADJUSTMENTS - by sam - 01-24-2014, 11:49 AM
RE: PHILCO 41-608 ADJUSTMENTS - by Randy H. - 01-24-2014, 03:23 PM
RE: PHILCO 41-608 ADJUSTMENTS - by davidff - 01-27-2014, 12:31 PM
RE: PHILCO 41-608 ADJUSTMENTS - by Randy H. - 01-27-2014, 01:54 PM
RE: PHILCO 41-608 ADJUSTMENTS - by davidff - 01-27-2014, 02:54 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>