01-24-2014, 11:48 PM
This might be a good way to reproduce knobs on rare radios that are basically impossible to find replacements for and a lot cheaper than a 3D printer!
No matter where you go, there you are.
reproduction knobs
« Next Oldest | Next Newest »
Messages In This Thread
reproduction knobs - by tab10672 - 01-24-2014, 10:43 PM
RE: reproduction knobs - by morzh - 01-24-2014, 10:48 PM
RE: reproduction knobs - by tab10672 - 01-24-2014, 10:53 PM
RE: reproduction knobs - by tab10672 - 01-24-2014, 10:58 PM
RE: reproduction knobs - by skyscraper - 01-24-2014, 10:59 PM
RE: reproduction knobs - by tab10672 - 01-24-2014, 11:03 PM
RE: reproduction knobs - by Jayce - 01-24-2014, 11:48 PM
RE: reproduction knobs - by Bob Andersen - 01-25-2014, 01:31 AM
RE: reproduction knobs - by OldRestorer - 01-25-2014, 08:07 AM
RE: reproduction knobs - by tab10672 - 01-25-2014, 02:16 PM
RE: reproduction knobs - by jerryhawthorne - 01-25-2014, 02:59 PM
RE: reproduction knobs - by Warren - 01-25-2014, 03:07 PM
RE: reproduction knobs - by tab10672 - 01-25-2014, 03:16 PM
RE: reproduction knobs - by Jamie - 01-25-2014, 05:04 PM
Users browsing this thread: 1 Guest(s) |
|