Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-670 capacitor questions
#12

Thank you all for all the advice. Whatever what value I decide to use on part 73 and 74, it will be very close to the voltage of the original caps.

Hopefully, Chucks schematic and service notes for my radio will be in today's mail.

Tom


Messages In This Thread
37-670 capacitor questions - by Tom Hamilton - 01-23-2014, 10:15 PM
RE: 37-670 capacitor questions - by hsusmann - 01-23-2014, 10:26 PM
RE: 37-670 capacitor questions - by morzh - 01-23-2014, 10:27 PM
RE: 37-670 capacitor questions - by Tom Hamilton - 01-23-2014, 11:08 PM
RE: 37-670 capacitor questions - by morzh - 01-24-2014, 12:36 AM
RE: 37-670 capacitor questions - by Tom Hamilton - 01-24-2014, 05:31 PM
RE: 37-670 capacitor questions - by OldRestorer - 01-25-2014, 07:57 AM
RE: 37-670 capacitor questions - by Tom Hamilton - 01-25-2014, 01:09 PM
RE: 37-670 capacitor questions - by Warren - 01-25-2014, 03:11 PM
RE: 37-670 capacitor questions - by Raleigh - 01-27-2014, 12:38 AM
RE: 37-670 capacitor questions - by exray - 01-27-2014, 06:28 AM
RE: 37-670 capacitor questions - by Tom Hamilton - 01-27-2014, 12:44 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM

[-]
Who's Online
There are currently 4046 online users. [Complete List]
» 2 Member(s) | 4044 Guest(s)
AvatarAvatar

>