1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 39-45... help?
morzh
Odobenus rosmarus
*****
Posts: 15,825
Threads: 554
Joined: Oct 2011
City: Jackson, NJ
#3

01-29-2014, 08:59 PM
Just go by schematic. Things have not changed much since, a capacitor is still a capacitor, a resistor is a resistor. A wire will still conduct current.
Gut the backelite blocks, stiff with new caps, do not even pot them again.....
The voltages are somewhat higher than today's ones so be careful: even on the states' levels electrocution is no longer legal.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 39-45... help? - by Dbwaibel - 01-29-2014, 03:02 PM
RE: Philco 39-45... help? - by tab10672 - 01-29-2014, 07:21 PM
RE: Philco 39-45... help? - by morzh - 01-29-2014, 08:59 PM
RE: Philco 39-45... help? - by Eric T - 01-29-2014, 09:06 PM
RE: Philco 39-45... help? - by BrendaAnnD - 01-29-2014, 09:10 PM
RE: Philco 39-45... help? - by Raleigh - 01-29-2014, 09:22 PM
RE: Philco 39-45... help? - by Raleigh - 01-29-2014, 09:35 PM
RE: Philco 39-45... help? - by Dbwaibel - 01-30-2014, 12:24 AM
RE: Philco 39-45... help? - by BrendaAnnD - 01-30-2014, 03:01 AM
RE: Philco 39-45... help? - by hsusmann - 01-30-2014, 09:26 AM
RE: Philco 39-45... help? - by Dbwaibel - 02-03-2014, 11:28 PM
RE: Philco 39-45... help? - by Raleigh - 02-04-2014, 12:05 AM
RE: Philco 39-45... help? - by Dbwaibel - 02-04-2014, 12:11 AM
RE: Philco 39-45... help? - by Dbwaibel - 02-04-2014, 12:31 AM
RE: Philco 39-45... help? - by skyscraper - 02-04-2014, 01:02 AM
RE: Philco 39-45... help? - by Dbwaibel - 02-04-2014, 08:43 PM
RE: Philco 39-45... help? - by morzh - 02-04-2014, 11:21 PM



Users browsing this thread: 9 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration