Philco 39-45... help?

Register

Guest Join Us

Hello Guest,

Please feel free to join us!
There are many more parts of the Phorum that only members can see.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 39-45... help?

Raleigh
Senior Member

Posts: 347
Threads: 34
Joined: May 2007
City: Raleigh, NC

#7

01-29-2014, 09:35 PM

P.S. You can also replace caps and resistors by cutting out the old ones close to the component body and then solder new components to the old leads that remain. It's easier than desoldering them, but it doesn't look as nice.

John Honeycutt

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 39-45... help? - by Dbwaibel - 01-29-2014, 03:02 PM

RE: Philco 39-45... help? - by tab10672 - 01-29-2014, 07:21 PM

RE: Philco 39-45... help? - by morzh - 01-29-2014, 08:59 PM

RE: Philco 39-45... help? - by Eric T - 01-29-2014, 09:06 PM

RE: Philco 39-45... help? - by BrendaAnnD - 01-29-2014, 09:10 PM

RE: Philco 39-45... help? - by Raleigh - 01-29-2014, 09:22 PM

RE: Philco 39-45... help? - by Raleigh - 01-29-2014, 09:35 PM

RE: Philco 39-45... help? - by Dbwaibel - 01-30-2014, 12:24 AM

RE: Philco 39-45... help? - by BrendaAnnD - 01-30-2014, 03:01 AM

RE: Philco 39-45... help? - by hsusmann - 01-30-2014, 09:26 AM

RE: Philco 39-45... help? - by Dbwaibel - 02-03-2014, 11:28 PM

RE: Philco 39-45... help? - by Raleigh - 02-04-2014, 12:05 AM

RE: Philco 39-45... help? - by Dbwaibel - 02-04-2014, 12:11 AM

RE: Philco 39-45... help? - by Dbwaibel - 02-04-2014, 12:31 AM

RE: Philco 39-45... help? - by skyscraper - 02-04-2014, 01:02 AM

RE: Philco 39-45... help? - by Dbwaibel - 02-04-2014, 08:43 PM

RE: Philco 39-45... help? - by morzh - 02-04-2014, 11:21 PM

View a Printable Version

Users browsing this thread: 10 Guest(s)

Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

Who's Online
There are currently no members online.