Philco 620B alignment woes

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 620B alignment woes

wonderwrench
Member

Posts: 96
Threads: 16
Joined: Oct 2007

06-21-2008, 12:51 PM

BDM Wrote:Bill, antenna connection are you using? The post on top of the chassis, or the screws on the back of the chassis?

I'm using the post on top. I just found an intermittent problem. On rare occasions the audio will drop down. I did some poking around but the problem went away before i could find the cause. At one point I thought I found a intermittent at the 75 tube. The darn thing refuses to act up.

Bill

It's not what you don't know that hurts you it's what you know that's not so.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 620B alignment woes - by wonderwrench - 06-19-2008, 06:29 PM

[No subject] - by wonderwrench - 06-20-2008, 07:02 PM

[No subject] - by BDM - 06-20-2008, 07:19 PM

[No subject] - by wonderwrench - 06-20-2008, 07:46 PM

[No subject] - by BDM - 06-20-2008, 07:58 PM

[No subject] - by wonderwrench - 06-20-2008, 08:03 PM

[No subject] - by wonderwrench - 06-21-2008, 11:52 AM

[No subject] - by BDM - 06-21-2008, 12:24 PM

[No subject] - by wonderwrench - 06-21-2008, 12:51 PM

[No subject] - by BDM - 06-21-2008, 01:16 PM

[No subject] - by rghines1 - 06-21-2008, 01:33 PM

[No subject] - by BDM - 06-21-2008, 11:56 PM

[No subject] - by wonderwrench - 06-23-2008, 03:26 PM

[No subject] - by wonderwrench - 06-23-2008, 04:03 PM

[No subject] - by etech - 06-23-2008, 06:33 PM

[No subject] - by wonderwrench - 06-29-2008, 06:23 PM

[No subject] - by wonderwrench - 07-06-2008, 12:26 PM

[No subject] - by Ron Ramirez - 07-06-2008, 02:46 PM

View a Printable Version

Users browsing this thread: 6 Guest(s)

Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me