[OldRestorer]

Well,
This sucks!
I was going through the Halson wiring and got the 40 and the 20 ready to replace the first large cap.
I was attaching the 40 to the neg and the pin 3-4 as we talked about and the neg lead on the 20 just broke off so it is no good. I took the last 20 I had and went to hook that up and the lead again from the neg just broke off. What crap are these Canadians selling? Now I have to wait and get a list of caps that will be over $20 just to get these 2 caps...
The 40 is hooked up and I know that the 20 goes from negative to pin 3 of the 43 tube but I just cant do it now.

The second cap is now what I am trying to figure out.
The negative runs to ground. The 1st positive runs to pin 4-5 of the 6C6 tube.
The 2nd pos wire runs to pin 5 of the 43 tube.

What I don't know is the values of the 2 replacement Ecaps, their voltages and if they are different values, which goes where.