1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Broken on/off switch
Diverted
Member
***
Posts: 79
Threads: 13
Joined: Feb 2014
City: Bristol, RI
#5

02-12-2014, 11:23 PM
The problem is accessing the little tab that the broken line was soldered to. It's recessed pretty far in from the bottom of the switch. I may grind out those rivets and try to open it up, so I can hopefully re-solder. I figure I have nothing to lose, as I'll likely be replacing it either way.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Broken on/off switch - by Diverted - 02-12-2014, 08:57 PM
RE: Broken on/off switch - by murf - 02-12-2014, 09:36 PM
RE: Broken on/off switch - by Arran - 02-12-2014, 09:44 PM
RE: Broken on/off switch - by morzh - 02-12-2014, 10:26 PM
RE: Broken on/off switch - by Diverted - 02-12-2014, 11:23 PM
RE: Broken on/off switch - by Warren - 02-12-2014, 11:43 PM
RE: Broken on/off switch - by BrendaAnnD - 02-13-2014, 02:02 AM
RE: Broken on/off switch - by Eric T - 02-13-2014, 08:24 AM
RE: Broken on/off switch - by Ron Ramirez - 02-13-2014, 12:26 PM
RE: Broken on/off switch - by morzh - 02-13-2014, 12:41 PM
RE: Broken on/off switch - by Warren - 02-13-2014, 01:59 PM
RE: Broken on/off switch - by Chuck Schwark - 02-13-2014, 02:04 PM
RE: Broken on/off switch - by Diverted - 02-13-2014, 02:21 PM
RE: Broken on/off switch - by Diverted - 02-14-2014, 04:50 PM
RE: Broken on/off switch - by morzh - 02-14-2014, 05:22 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration