Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 70 pm speaker
#7

I would not even clip teh wire - what if one day you get the real thing and decide to use the 20 for some 20 you at the time will be working on.
Just roll it up tight and wrap in insulating tape.

BTW the 2766 transformer is shown as both PP and SE for 47 tube in Chuck's transformer table on the Philco Repair Bench website.


Messages In This Thread
Model 70 pm speaker - by tab10672 - 02-11-2014, 06:47 PM
RE: Model 70 pm speaker - by morzh - 02-11-2014, 09:40 PM
RE: Model 70 pm speaker - by TV MAN - 02-13-2014, 06:30 PM
RE: Model 70 pm speaker - by tab10672 - 02-13-2014, 06:46 PM
RE: Model 70 pm speaker - by morzh - 02-13-2014, 06:52 PM
RE: Model 70 pm speaker - by TV MAN - 02-13-2014, 08:44 PM
RE: Model 70 pm speaker - by morzh - 02-13-2014, 09:36 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM
Restoring Philco 96
I have eventually replaced the speaker and shot the video, which only shows the upper part of the dial as the hum is ver...morzh — 09:24 PM
Rogers Majestic R-646
Kinda weird to see both open Nothing weird if you remember that this radio is about 100 years old  :)Vlad95 — 07:49 PM
Philco 42-345 Restoration/Repair
I believe I'm making progress, resistors have been rechecked and corrected, removed that ugly blue capacitor and more wi...osanders0311 — 07:38 PM
Philco Model 16 wiring question
Thanks Morzh Yes I recapped everything and replaced almost all the resistors as well. I redid #99 with .015 safety ca...bobclausen — 07:11 PM
Philco Model 16 wiring question
Well...pull out every single load of the transformer. For every winding. Unsolder if needed. Then re-do your dim bulb....morzh — 07:02 PM
Rogers Majestic R-646
Kinda weird to see both open, but once you get it up and running, really pay attention to your sound. Listen for loud cr...TV MAN — 06:59 PM

[-]
Who's Online
There are currently 961 online users. [Complete List]
» 2 Member(s) | 959 Guest(s)
AvatarAvatar

>