Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Dropping net
#1

HI All
For years I have had a local transmitter, transmitting Old Time Radio 24/7. Icon_smile I use winamp and it would drop the connection about once or twice a week. Now all of sudden it drops every 10 or 15 minutes. I have to go and click on the play button. Icon_mad . I am not a computer expert, any ideas?? Icon_confused
Joe

Joe Bratcher near Louisville, KY


Messages In This Thread
Dropping net - by w4rtc - 02-21-2014, 05:51 PM
RE: Dropping net - by Ron Ramirez - 02-21-2014, 07:19 PM
RE: Dropping net - by Raleigh - 02-23-2014, 01:22 AM
RE: Dropping net - by Ron Ramirez - 02-23-2014, 08:57 PM
RE: Dropping net - by morzh - 02-23-2014, 09:26 PM
RE: Dropping net - by skyscraper - 02-23-2014, 09:55 PM
RE: Dropping net - by w4rtc - 02-23-2014, 10:05 PM
RE: Dropping net - by w4rtc - 02-23-2014, 10:09 PM



Users browsing this thread: 8 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 7311 online users. [Complete List]
» 2 Member(s) | 7309 Guest(s)
AvatarAvatar

>