Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 40-120 Restoration
#2

Since it is a series strung set (no power transformer) the B+ comes directly from the line voltage. Probably what was in there were 150v
electrolytics but I would go with 250v or 350v new ones. 350v is probably
overkill but I would err on the side of higher voltage rating rather
than 150v. Lifetime ratings for electyolytic caps depend on temperature
and how close to the rated voltage rating you are running them.

Try to get 105 degree C rated caps also.

Herb S.
Ithaca NY


Messages In This Thread
Philco 40-120 Restoration - by jd3 - 02-22-2014, 10:54 AM
RE: Philco 40-120 Restoration - by hsusmann - 02-22-2014, 11:37 AM
RE: Philco 40-120 Restoration - by jd3 - 02-24-2014, 12:19 AM
RE: Philco 40-120 Restoration - by Warren - 02-24-2014, 01:56 AM
RE: Philco 40-120 Restoration - by morzh - 02-24-2014, 11:32 AM
RE: Philco 40-120 Restoration - by skyscraper - 02-24-2014, 11:55 AM
RE: Philco 40-120 Restoration - by hsusmann - 02-24-2014, 12:19 PM
RE: Philco 40-120 Restoration - by jd3 - 02-24-2014, 06:50 PM
RE: Philco 40-120 Restoration - by jd3 - 02-24-2014, 06:57 PM
RE: Philco 40-120 Restoration - by vinzer - 02-24-2014, 07:18 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
The 2 towns you mentioned "Frustrated" and "Give Up" are places we have all been. Relax, take 5, thi...Paul Philco322 — 03:23 PM
Philco 89 Code 123 Osc Coil
Thanks for posting that information!klondike98 — 03:14 PM
Philco 42-345 Restoration/Repair
From what I see is the blue cap was added by someone after the radio was sold presumably to replace cap 40A. I can't tel...RodB — 03:12 PM
Philco 42-345 Restoration/Repair
Correction My original picture shows #40 cap, blue cap and #42 resistor connected.osanders0311 — 02:23 PM
Philco 42-345 Restoration/Repair
Well guys I am stuck, frustrated and about ready to give up. For starters all I'm getting from the speaker is a humming ...osanders0311 — 02:17 PM
[split] New member...
Thanks.  I'll try that.HowardWoodard — 01:13 PM
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM

[-]
Who's Online
There are currently 1103 online users. [Complete List]
» 4 Member(s) | 1099 Guest(s)
AvatarAvatarAvatarAvatar

>