1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
42-RP2 help needed
Chris Drumma
Member
***
Posts: 103
Threads: 48
Joined: Nov 2005
City: Freehold, NY
#1

11-30-2005, 07:16 AM
I bought one off e-bay and need some help placing some loose wires and figuring out what the person did.

1. I need to know what and where to get a crystal cartridge and needle for this.
2. The crystal cartridge wires where do they connect to the chassis? I have the schematic but can't figure it out.
3. The phono motor wires one is connected to the tone arm plunger assembly. Where does the other one go?
4. The previous owner connect a small plug to the chassis. I am assuming to to plug into a speaker. One of the wires is connected to the chassis, the other one is connected to pin 5 of the 6A7 tube.

If any one has one of these and could help out or send some pictures I would appreciate it.
thanks
Chris
Find
« Next Oldest | Next Newest »


Messages In This Thread
42-RP2 help needed - by Chris Drumma - 11-30-2005, 07:16 AM
[No subject] - by Chuck Schwark - 11-30-2005, 09:37 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently 4036 online users. [Complete List]
» 3 Member(s) | 4033 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration