Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 37-610
#7

I'm assuming we're talking a 37-610T so An S-7 speaker. Cribbing from Ron's spreadsheet it was used on:
60, 260B, 37-60, 37-61, 37-62, 37-610B-T, 37-620B, 37-2620B, 38-62, 38-9T, 38-10T, 38-60, 38-620

Looks like an S-12 used on 66B and 66S or an S-14 used on 610F, 610T, 620, 625 should work as well'

Link to Ron's speaker spreadsheet: http://www.philcoradio.com/phorum/showth...hp?tid=215

it is the aptly named spkrs.zip file

John
Las Vegas, NV USA


Messages In This Thread
Philco 37-610 - by Section10 - 02-26-2014, 07:01 PM
RE: Philco 37-610 - by Warren - 02-26-2014, 08:39 PM
RE: Philco 37-610 - by morzh - 02-26-2014, 09:05 PM
RE: Philco 37-610 - by Section10 - 02-26-2014, 10:14 PM
RE: Philco 37-610 - by PAradiogeek - 02-27-2014, 12:00 AM
RE: Philco 37-610 - by Arran - 02-27-2014, 12:43 AM
RE: Philco 37-610 - by LASJayhawk - 02-28-2014, 07:19 PM
RE: Philco 37-610 - by PhilcoJohn - 03-11-2014, 09:18 PM
RE: Philco 37-610 - by Tom Hamilton - 03-16-2014, 08:33 PM
RE: Philco 37-610 - by PhilcoJohn - 03-17-2014, 07:38 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 3779 online users. [Complete List]
» 1 Member(s) | 3778 Guest(s)
Avatar

>