Rubber Chassis Bits....

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Rubber Chassis Bits....

Robbie Roberts
Member

Posts: 147
Threads: 28
Joined: Nov 2005

12-01-2005, 06:24 PM

I have been scouering both great Philco sites, looking for the answer, but haven't found it yet... Does anyone have a source for the rubber bits which support/mount the RF subchassis to the main chassis for the 37-650? I am referring to the two(one each side) which support the front of the subchassis, and are roughly top-hat shaped, and the one into which the tuning condensor unit goes at the back.(also top-hat shaped)

Mine are expired, and I have a few ideas on some alternate replacements, but I wanted to see if anyone else had a source for good repro's or such...

I am not worried about the flat chassis to cabinet washers- I found them easily.

Thanks!
Scott

Old Cars, Old Radios, Old Pipes and Young Women... What more is there?

Find

« Next Oldest | Next Newest »

Messages In This Thread

Rubber Chassis Bits.... - by Robbie Roberts - 12-01-2005, 06:24 PM

[No subject] - by Bill Hutchinson - 12-01-2005, 07:42 PM

Bits Reply - by Robbie Roberts - 12-01-2005, 07:52 PM

Rubber pieces - by Guest - 12-01-2005, 11:27 PM

Rubber Bits - by Robbie Roberts - 12-02-2005, 08:12 AM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me