[wjheil]

Hi,

I am trying to restore a D10 turntable from a Philco 46-1209.

The motor is very stiff. I removed it and oiled the bushings. It is better but still too stiff. Also when I apply power to it through a variac I get no response. No hum or indication of any sort. The motor winding measures 40 ohms.

There is a 50 ohm wire wound resistor in series with the motor winding. It has some of the winding exposed on one side for a possible tap.

It does not appear in the manual I have.

Any suggestions? Are replacement motors available?

Thanks,
Wayne