Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 60 Code 121
#12

Where did you apply the signal from the generator? I wonder if connecting the generator at that point affected the tuning of that particular circuit? Which trimmer needed to be retuned?

In any case, if you are now getting good AVC voltage and no distortion, then all is well.


Messages In This Thread
Model 60 Code 121 - by gregb - 03-04-2014, 11:36 PM
RE: Model 60 Code 121 - by Mondial - 03-05-2014, 12:29 AM
RE: Model 60 Code 121 - by gregb - 03-05-2014, 12:41 AM
RE: Model 60 Code 121 - by Mondial - 03-05-2014, 12:55 AM
RE: Model 60 Code 121 - by gregb - 03-05-2014, 01:02 AM
RE: Model 60 Code 121 - by Mondial - 03-05-2014, 12:43 PM
RE: Model 60 Code 121 - by gregb - 03-05-2014, 08:25 PM
RE: Model 60 Code 121 - by gregb - 03-06-2014, 01:06 AM
RE: Model 60 Code 121 - by Mondial - 03-06-2014, 10:35 AM
RE: Model 60 Code 121 - by gregb - 03-06-2014, 10:58 AM
RE: Model 60 Code 121 - by gregb - 03-07-2014, 01:30 PM
RE: Model 60 Code 121 - by Mondial - 03-07-2014, 10:32 PM
RE: Model 60 Code 121 - by gregb - 03-07-2014, 10:38 PM
RE: Model 60 Code 121 - by Mondial - 03-07-2014, 11:22 PM
RE: Model 60 Code 121 - by gregb - 03-07-2014, 11:55 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
The 2 towns you mentioned "Frustrated" and "Give Up" are places we have all been. Relax, take 5, thi...Paul Philco322 — 03:23 PM
Philco 89 Code 123 Osc Coil
Thanks for posting that information!klondike98 — 03:14 PM
Philco 42-345 Restoration/Repair
From what I see is the blue cap was added by someone after the radio was sold presumably to replace cap 40A. I can't tel...RodB — 03:12 PM
Philco 42-345 Restoration/Repair
Correction My original picture shows #40 cap, blue cap and #42 resistor connected.osanders0311 — 02:23 PM
Philco 42-345 Restoration/Repair
Well guys I am stuck, frustrated and about ready to give up. For starters all I'm getting from the speaker is a humming ...osanders0311 — 02:17 PM
[split] New member...
Thanks.  I'll try that.HowardWoodard — 01:13 PM
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM

[-]
Who's Online
There are currently 1022 online users. [Complete List]
» 4 Member(s) | 1018 Guest(s)
AvatarAvatarAvatarAvatar

>