Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

46-1203 / Low Phono Volume Question
#7

Hmm, can't say I'm totally clear on that jerryhawthorne. At least with the cartridge (Shure W60B) that's installed now, there's a rubber shroud over the output wires on the underside of the tone arm/cartridge (red / black, the grounding goes to the mesh of the cable) so I can't get at either with any sort of wire without pulling the whole tone-arm off, unscrewing the cartridge, and trying that way (which, let me tell you, I'm bound to try here in about 10 minutes).

Noticed with the volume for the phono, audio does come out of the speaker, but the only thing that gets louder with turning the volume knob is the ac hum/drone, the music itself seems to stay about the same from halfway to full volume!


Messages In This Thread
46-1203 / Low Phono Volume Question - by sbish - 03-06-2014, 02:56 PM
RE: 46-1203 / Low Phono Volume Question - by sbish - 03-08-2014, 11:24 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
The 2 towns you mentioned "Frustrated" and "Give Up" are places we have all been. Relax, take 5, thi...Paul Philco322 — 03:23 PM
Philco 89 Code 123 Osc Coil
Thanks for posting that information!klondike98 — 03:14 PM
Philco 42-345 Restoration/Repair
From what I see is the blue cap was added by someone after the radio was sold presumably to replace cap 40A. I can't tel...RodB — 03:12 PM
Philco 42-345 Restoration/Repair
Correction My original picture shows #40 cap, blue cap and #42 resistor connected.osanders0311 — 02:23 PM
Philco 42-345 Restoration/Repair
Well guys I am stuck, frustrated and about ready to give up. For starters all I'm getting from the speaker is a humming ...osanders0311 — 02:17 PM
[split] New member...
Thanks.  I'll try that.HowardWoodard — 01:13 PM
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM

[-]
Who's Online
There are currently 992 online users. [Complete List]
» 3 Member(s) | 989 Guest(s)
AvatarAvatarAvatar

>