Philco 37-610

Thread Rating:

Philco 37-610

PhilcoJohn
Phorum Expert

Posts: 1,463
Threads: 97
Joined: Jul 2012
City: Poughkeepsie, N.Y.

#10

03-17-2014, 07:38 PM

Tom thanks for posting this. I will watch this video. Thanks again.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 37-610 - by Section10 - 02-26-2014, 07:01 PM

RE: Philco 37-610 - by Warren - 02-26-2014, 08:39 PM

RE: Philco 37-610 - by morzh - 02-26-2014, 09:05 PM

RE: Philco 37-610 - by Section10 - 02-26-2014, 10:14 PM

RE: Philco 37-610 - by PAradiogeek - 02-27-2014, 12:00 AM

RE: Philco 37-610 - by Arran - 02-27-2014, 12:43 AM

RE: Philco 37-610 - by LASJayhawk - 02-28-2014, 07:19 PM

RE: Philco 37-610 - by PhilcoJohn - 03-11-2014, 09:18 PM

RE: Philco 37-610 - by PhilcoJohn - 03-17-2014, 07:38 PM

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6561 online users. [Complete List]
» 6 Member(s) | 6555 Guest(s)