Philco 38-7CS decal question

Thread Rating:

Ron Ramirez
Silent Key

Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana

12-04-2005, 10:39 AM

Hi Robbie (or is it Scott?)

Again, only the PHILCO trademark, no others.

[Image: http://i326.photobucket.com/albums/k420/...decal3.jpg]

--
Ron Ramirez
Ferdinand IN

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 38-7CS decal question - by Guest - 10-24-2005, 01:06 PM

[No subject] - by Ron Ramirez - 10-24-2005, 01:28 PM

Thanks Ron! - by Guest - 10-25-2005, 12:57 AM

[No subject] - by Ron Ramirez - 12-04-2005, 10:39 AM

Thanks, Ron! - by Robbie Roberts - 12-04-2005, 12:50 PM

[No subject] - by panther - 01-15-2006, 02:07 AM

[No subject] - by Ron Ramirez - 01-15-2006, 02:29 AM

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

Who's Online

There are currently 4903 online users. [Complete List]
» 2 Member(s) | 4901 Guest(s)