Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

42-380 + ?? escutcheon panel
#1

As I mentioned before, I have two 42-380s in the restoration queue.

As I looked more closely at the front panels, I noticed the metal strip that defines the controls were different:
#1 Bass, Volume, Bands, Tuning
#2 Volume, Bass, Treble, Tuning.

Based on what I can interpret from the schematic, I have to assume that #2 is the correct strip. Both chassis are marked 42-380 Code 121, and the cabinets are otherwise identical.

I then have to assume the other escutcheon panel is for a similar console, but clearly not a 42-380.

Since I really have no use for it, it's up for grabs if someone needs it.

Ira


Messages In This Thread
42-380 + ?? escutcheon panel - by irawex - 03-30-2014, 05:24 PM
RE: 42-380 + ?? escutcheon panel - by Raleigh - 03-30-2014, 11:01 PM
RE: 42-380 + ?? escutcheon panel - by irawex - 03-31-2014, 09:23 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6492 online users. [Complete List]
» 5 Member(s) | 6487 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>