Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-10
#4

Very sorry to hear about your mom's decline, Kevin. Sadly, that happens all too often when people who have been together for decades suddenly lose their spouse. Sending positive thoughts your way.

Funny thing, it must be 38-10 weekend in Southeastern Wisconsin! Icon_lol I was just going through mine as well yesterday. Finally got around to giving it the complete recap it needed. It seems this set is right at the tail end of the bakelite block era... there's just one lone one to re-stuff. Yours looks very nice. Especially the photo finish! Good find.

Greg V.
West Bend, WI
Member WARCI.org


Messages In This Thread
Philco 38-10 - by 37silverstreak - 03-30-2014, 06:24 PM
RE: Philco 38-10 - by OldRestorer - 03-30-2014, 07:13 PM
RE: Philco 38-10 - by klondike98 - 03-30-2014, 07:39 PM
RE: Philco 38-10 - by NostalgiaRadioTime - 03-30-2014, 07:55 PM
RE: Philco 38-10 - by TA Forbes - 03-30-2014, 11:32 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6990 online users. [Complete List]
» 2 Member(s) | 6988 Guest(s)
AvatarAvatar

>