Small RF Oscilaltors.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Small RF Oscilaltors.

BrendaAnnD
Phorum Expert

Posts: 1,108
Threads: 89
Joined: Jun 2011
City: Tacoma State, Province, Country: Washington

04-04-2014, 04:35 PM

Some distortion was designed into those old RF generators, in order to get harmonic output. Many radio manufacturers call for you to set a signal generator at a relatively low output frequency, and use harmonics of the output when moving from band to band doing an alignment. Also, that entire highest band is entirely harmonic output. IIRC, they use 3rd harmonic, as odd numbered harmonics are higher in energy than even.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Small RF Oscilaltors. - by morzh - 02-19-2014, 12:28 AM

RE: Small RF Oscilaltors. - by TV MAN - 04-04-2014, 02:04 PM

RE: Small RF Oscilaltors. - by codefox1 - 04-04-2014, 02:55 PM

RE: Small RF Oscilaltors. - by BrendaAnnD - 04-04-2014, 04:35 PM

RE: Small RF Oscilaltors. - by morzh - 04-04-2014, 06:55 PM

RE: Small RF Oscilaltors. - by TV MAN - 04-05-2014, 10:39 AM

RE: Small RF Oscilaltors. - by morzh - 04-05-2014, 02:50 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me