Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Dynaco, Dynakits, etc.
#8

They used a little bitty selenium rectifier for the bias. I know that became a problem, but is easy to fix now.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/


Messages In This Thread
Dynaco, Dynakits, etc. - by Phlogiston - 04-01-2014, 06:10 PM
RE: Dynaco, Dynakits, etc. - by Ron Ramirez - 04-04-2014, 09:50 PM
RE: Dynaco, Dynakits, etc. - by TV MAN - 04-05-2014, 10:55 AM
RE: Dynaco, Dynakits, etc. - by codefox1 - 04-05-2014, 12:48 PM
RE: Dynaco, Dynakits, etc. - by Phlogiston - 04-05-2014, 05:23 PM
RE: Dynaco, Dynakits, etc. - by Raleigh - 04-11-2014, 10:22 AM
RE: Dynaco, Dynakits, etc. - by Phlogiston - 04-11-2014, 11:35 AM
RE: Dynaco, Dynakits, etc. - by Raleigh - 04-11-2014, 02:39 PM
RE: Dynaco, Dynakits, etc. - by Phlogiston - 04-11-2014, 05:57 PM
RE: Dynaco, Dynakits, etc. - by wireless - 04-23-2014, 07:34 PM
RE: Dynaco, Dynakits, etc. - by radiohenry - 04-27-2014, 08:11 AM
RE: Dynaco, Dynakits, etc. - by Joeztech - 06-05-2014, 07:40 PM
RE: Dynaco, Dynakits, etc. - by Arran - 06-05-2014, 11:09 PM
RE: Dynaco, Dynakits, etc. - by exray - 06-12-2014, 05:26 PM
RE: Dynaco, Dynakits, etc. - by Phlogiston - 06-12-2014, 06:21 PM
RE: Dynaco, Dynakits, etc. - by bfrohwein - 06-12-2014, 08:43 PM
RE: Dynaco, Dynakits, etc. - by gregb - 06-12-2014, 08:50 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 2804 online users. [Complete List]
» 3 Member(s) | 2801 Guest(s)
AvatarAvatarAvatar

>