Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My new 42-1012
#8

Congratulations, Kevin! Icon_clap Icon_thumbup

The door linked above on eBay will not fit your cabinet. You will need one from a 42-1012 or a 41-610. Empty cabinets of those models pop up from time to time. Maybe one of you guys going to Kutztown could look for one of these for Kevin, or even save one from a cabinet destined for the Friday night flame?

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
My new 42-1012 - by 37silverstreak - 04-05-2014, 06:40 PM
RE: My new 42-1012 - by sam - 04-05-2014, 06:57 PM
RE: My new 42-1012 - by Radioroslyn - 04-05-2014, 07:10 PM
RE: My new 42-1012 - by gregb - 04-05-2014, 08:41 PM
RE: My new 42-1012 - by NostalgiaRadioTime - 04-05-2014, 09:32 PM
RE: My new 42-1012 - by Bill Kinghorn - 04-05-2014, 09:46 PM
RE: My new 42-1012 - by Bill Kinghorn - 04-05-2014, 09:54 PM
RE: My new 42-1012 - by Ron Ramirez - 04-06-2014, 07:47 AM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6469 online users. [Complete List]
» 4 Member(s) | 6465 Guest(s)
AvatarAvatarAvatarAvatar

>