Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

42-350 brass escutcheon-FOUND
#6

The patina makes it look like the plate has not been gone too long.

If you haven't had the 42-350 too long, might think about the price of brass at scrap yards.

Might take a picture to your local scrap yard and see if it has found it's way there. My local one lets me wounder out looking for treasures, but that's small town behavior. Brass collects slowly so there may be a slight chance.


Messages In This Thread
42-350 brass escutcheon-FOUND - by Eric Adams - 04-03-2014, 05:51 PM
RE: 42-350 brass escutcheon - by Arran - 04-04-2014, 12:15 AM
RE: 42-350 brass escutcheon - by Eric Adams - 04-04-2014, 01:21 AM
RE: 42-350 brass escutcheon - by K7Sparky - 04-04-2014, 04:00 PM
RE: 42-350 brass escutcheon - by Eric Adams - 04-04-2014, 05:36 PM
RE: 42-350 brass escutcheon-FOUND - by K7Sparky - 04-06-2014, 03:53 PM
RE: 42-350 brass escutcheon-FOUND - by K7Sparky - 04-06-2014, 04:49 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Not sure if anyone has tried this but there are 6.3 volt miniature lamps in bayonet and screw-in base options available ...GarySP — 11:31 AM
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM

[-]
Who's Online
There are currently 8027 online users. [Complete List]
» 1 Member(s) | 8026 Guest(s)
Avatar

>