1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Speaker repair tutorial
Phlogiston
Radio-Fixer-Upper
*****
Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)
#3

04-09-2014, 09:44 AM
I started making the cones for those Philcos. They are different than most other speakers but there are a LOT of them. I also began to manufacture other cones. The ones that I was seeing from the speaker shops were not exact replacements anyway (appearance) and they were very stiff, like the ones for new high-powered stereo equipment. This is one of the early ones but the only picture I have at this time.

   
"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
(This post was last modified: 04-09-2014, 09:50 AM by Phlogiston.)
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
Speaker repair tutorial - by OldRestorer - 04-09-2014, 08:28 AM
RE: Speaker repair tutorial - by morzh - 04-09-2014, 09:21 AM
RE: Speaker repair tutorial - by Phlogiston - 04-09-2014, 09:44 AM
RE: Speaker repair tutorial - by captainslack - 04-09-2014, 01:36 PM
RE: Speaker repair tutorial - by K7Sparky - 04-10-2014, 07:11 AM
RE: Speaker repair tutorial - by TA Forbes - 04-10-2014, 01:03 PM
RE: Speaker repair tutorial - by OldRestorer - 04-10-2014, 06:32 PM
RE: Speaker repair tutorial - by voroush - 04-16-2014, 03:26 PM
RE: Speaker repair tutorial - by mornflt - 08-25-2014, 02:20 PM
RE: Speaker repair tutorial - by Ron Ramirez - 08-25-2014, 06:04 PM
RE: Speaker repair tutorial - by radiohenry - 08-25-2014, 06:49 PM
RE: Speaker repair tutorial - by Ron Ramirez - 08-25-2014, 08:26 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration