116X Help

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

116X Help

gregb
Senior Member

Posts: 599
Threads: 24
Joined: Jan 2014
City: Edmonton AB CA

04-13-2014, 11:41 AM

My set has the 6A3 output tubes. There are a number of small changes and if they are original to the set or not is hard to say but they look like they could be. The most obvious is a 50k ohm resistor in series with the coupling cap to the centre terminal of the volume control. It is a dogbone of the correct style as the rest of them and sure does look factory. There are more but that sticks out in my mind, I will have to document the others.

Gregb

(This post was last modified: 04-13-2014, 11:42 AM by gregb.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

116X Help - by gregb - 04-12-2014, 04:42 PM

RE: 116X Help - by morzh - 04-12-2014, 07:06 PM

RE: 116X Help - by gregb - 04-12-2014, 07:49 PM

RE: 116X Help - by TA Forbes - 04-13-2014, 10:13 AM

RE: 116X Help - by gregb - 04-13-2014, 11:41 AM

RE: 116X Help - by TA Forbes - 04-13-2014, 04:19 PM

RE: 116X Help - by gregb - 04-13-2014, 07:21 PM

RE: 116X Help - by gregb - 04-14-2014, 11:15 AM

RE: 116X Help - by TA Forbes - 04-14-2014, 12:40 PM

RE: 116X Help - by gregb - 04-14-2014, 05:25 PM

RE: 116X Help - by TA Forbes - 04-14-2014, 11:42 PM

RE: 116X Help - by gregb - 04-14-2014, 11:52 PM

RE: 116X Help - by gregb - 04-15-2014, 10:12 AM

RE: 116X Help - by gregb - 04-16-2014, 09:06 PM

RE: 116X Help - by gregb - 04-16-2014, 10:07 PM

RE: 116X Help - by Mondial - 04-16-2014, 11:20 PM

RE: 116X Help - by gregb - 04-17-2014, 09:12 AM

RE: 116X Help - by Mondial - 04-17-2014, 11:19 AM

RE: 116X Help - by gregb - 04-17-2014, 12:54 PM

RE: 116X Help - by Mondial - 04-17-2014, 03:38 PM

RE: 116X Help - by gregb - 04-17-2014, 04:43 PM

RE: 116X Help - by Mondial - 04-17-2014, 08:15 PM

RE: 116X Help - by gregb - 04-17-2014, 08:28 PM

RE: 116X Help - by gregb - 04-17-2014, 10:30 PM

RE: 116X Help - by bfrohwein - 04-18-2014, 12:22 PM

RE: 116X Help - by gregb - 04-18-2014, 01:03 PM

RE: 116X Help - by bfrohwein - 04-18-2014, 02:25 PM

RE: 116X Help - by gregb - 04-18-2014, 02:40 PM

RE: 116X Help - by bfrohwein - 04-23-2014, 10:21 AM

View a Printable Version

Users browsing this thread: 12 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me