Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 50-1422
#1

Hello all! I currently have a 50-1422 Philco radio/turntable combo and am trying to determine how to repair it so that I can put it up for sale. The radio does not come on, which I assume could be a tube issue, nor does sound come out of the speakers. The turntable turns as it should but makes a clicking sound. It does appear the needle is in good working order, as I can hear sound coming off of the record itself, but there is also a small box of replacement needles with the unit. Thanks for any assistance!


Messages In This Thread
Philco 50-1422 - by Turning Pages - 04-17-2014, 01:04 PM
RE: Philco 50-1422 - by Warren - 04-17-2014, 03:27 PM
RE: Philco 50-1422 - by Turning Pages - 04-17-2014, 03:50 PM
RE: Philco 50-1422 - by Warren - 04-17-2014, 10:49 PM
RE: Philco 50-1422 - by Turning Pages - 04-18-2014, 06:44 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6477 online users. [Complete List]
» 4 Member(s) | 6473 Guest(s)
AvatarAvatarAvatarAvatar

>