87

Thread Rating:

morzh
Odobenus rosmarus

Posts: 15,823
Threads: 554
Joined: Oct 2011
City: Jackson, NJ

04-18-2014, 11:14 AM

the trnsformer is described in Chuck's website.
The ratio is 1:4.
The primary is about 1.4k, one of the output halves meaures at 3.2k.

Find

« Next Oldest | Next Newest »

Messages In This Thread

87 - by skyscraper - 03-30-2014, 06:15 PM

RE: 87 - by TA Forbes - 03-30-2014, 11:39 PM

RE: 87 - by skyscraper - 03-31-2014, 01:44 PM

RE: 87 - by morzh - 04-17-2014, 08:14 PM

RE: 87 - by skyscraper - 04-17-2014, 10:42 PM

RE: 87 - by morzh - 04-18-2014, 11:14 AM

RE: 87 - by Radioroslyn - 04-26-2014, 04:38 PM

RE: 87 - by TA Forbes - 04-27-2014, 09:03 AM

Users browsing this thread: 1 Guest(s)

Recent Posts
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM

Who's Online

There are currently 4993 online users. [Complete List]
» 1 Member(s) | 4992 Guest(s)