Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

620b - worth it? (Bought it)
#14

While we're on the topic, what about a 37-650 for $60? http://charlotte.craigslist.org/atq/4433729382.html

I don't have room for it unless it's something really special. Wouldn't mind a shadow meter...

This is getting ridiculous Icon_biggrin


Messages In This Thread
620b - worth it? (Bought it) - by skyscraper - 04-18-2014, 12:47 PM
RE: 620b - worth it? - by Mondial - 04-18-2014, 12:57 PM
RE: 620b - worth it? - by vinzer - 04-18-2014, 12:58 PM
RE: 620b - worth it? - by skyscraper - 04-18-2014, 01:36 PM
RE: 620b - worth it? - by Jayce - 04-18-2014, 01:45 PM
RE: 620b - worth it? - by Ron Ramirez - 04-18-2014, 03:52 PM
RE: 620b - worth it? - by skyscraper - 04-18-2014, 05:23 PM
RE: 620b - worth it? - by morzh - 04-18-2014, 06:16 PM
RE: 620b - worth it? - by skyscraper - 04-18-2014, 07:02 PM
RE: 620b - worth it? - by Eric Adams - 04-18-2014, 07:14 PM
RE: 620b - worth it? - by fegravel - 04-21-2014, 10:09 PM
RE: 620b - worth it? - by skyscraper - 04-21-2014, 11:07 PM
RE: 620b - worth it? - by fegravel - 04-21-2014, 11:13 PM
RE: 620b - worth it? - by skyscraper - 04-22-2014, 07:14 PM
RE: 620b - worth it? - by Ron Ramirez - 04-22-2014, 07:22 PM
RE: 620b - worth it? - by fegravel - 04-22-2014, 07:40 PM
RE: 620b - worth it? - by skyscraper - 04-22-2014, 07:40 PM
RE: 620b - worth it? - by skyscraper - 04-26-2014, 05:42 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently no members online.

>