1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco bakelite block 7762 B
Robbie Roberts
Member
***
Posts: 147
Threads: 28
Joined: Nov 2005
#2

12-06-2005, 08:13 PM
http://www.philcorepairbench.com/bblokcap.htm

Check Chuck's site(link above) and part way down the page he has:

CONDENSER TYPE 7762
Working Voltage 600

Part No. 7762-B

Lugs Used 1-3-6-8
Cond. Mfd. .001 1&8-6
Cond. Mfd. .015 3-6

and the pic, of course.

He might send a better link.

Scott
Old Cars, Old Radios, Old Pipes and Young Women... What more is there?
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco bakelite block 7762 B - by Chris Drumma - 12-06-2005, 07:42 PM
[No subject] - by Robbie Roberts - 12-06-2005, 08:13 PM
[No subject] - by Chuck Schwark - 12-06-2005, 08:26 PM
[No subject] - by don'tdomelikethat - 12-06-2005, 08:30 PM
[No subject] - by don'tdomelikethat - 12-06-2005, 08:42 PM
[No subject] - by Ron Ramirez - 12-06-2005, 08:47 PM
[No subject] - by Chris Drumma - 12-07-2005, 04:49 AM
[No subject] - by don'tdomelikethat - 12-07-2005, 07:23 AM
[No subject] - by Chris Drumma - 12-07-2005, 07:30 AM
[No subject] - by Ron Ramirez - 12-07-2005, 09:26 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration