to flux or not to flux

Thread Rating:

Chuck Schwark
Phorum Expert

Posts: 1,703
Threads: 55
Joined: Sep 2005
City: Evanston, IL

04-25-2014, 10:10 AM

I use Kester Rosin Past Flux.

Still have a metal tin of it since the 60s.
Lasts essentially forever.

"A little dab will do ya".

Chuck

« Next Oldest | Next Newest »

Messages In This Thread

to flux or not to flux - by murf - 04-24-2014, 06:26 PM

RE: to flux or not to flux - by Chuck Schwark - 04-25-2014, 10:10 AM

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM

Who's Online
There are currently no members online.