Philco bakelite block 7762 B

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

don'tdomelikethat
Unregistered

12-06-2005, 08:42 PM

Sorry. My lame attempt at posting a photo failed. Looking at the drawing on Chuck's website, Your .001 cap gets hooked to pins 1, 8, 6. Your .015 cap hooks to pins 3 & 6.

« Next Oldest | Next Newest »

Messages In This Thread

Philco bakelite block 7762 B - by Chris Drumma - 12-06-2005, 07:42 PM

[No subject] - by Robbie Roberts - 12-06-2005, 08:13 PM

[No subject] - by Chuck Schwark - 12-06-2005, 08:26 PM

[No subject] - by don'tdomelikethat - 12-06-2005, 08:30 PM

[No subject] - by don'tdomelikethat - 12-06-2005, 08:42 PM

[No subject] - by Ron Ramirez - 12-06-2005, 08:47 PM

[No subject] - by Chris Drumma - 12-07-2005, 04:49 AM

[No subject] - by don'tdomelikethat - 12-07-2005, 07:23 AM

[No subject] - by Chris Drumma - 12-07-2005, 07:30 AM

[No subject] - by Ron Ramirez - 12-07-2005, 09:26 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 6497 online users. [Complete List]
» 2 Member(s) | 6495 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me